Specifications

CY3214-PSoCEVALUSB Kit Guide, Doc No. 001-67030 Rev. *B 17
Kit Operation
Figure 3-3. PSoC Programmer Screen
Follow these steps to program using MiniProg1:
1. Connect the USB cable to the PC and MiniProg1
2. Plug in the MiniProg1 to the ISSP header on the CY3214-PSoCEVALUSB board
3. When USB is connected to the MiniProg1, the LED (green) glows in the MiniProg1
4. Open PSoC Programmer
5. Click the Load File button and browse to the hex file location. Click Open to select the hex file
6. Click Connect or double-click on the respective MiniProg under Port Selection to select or con-
nect to MiniProg
7. Click Program or press [F5] to initiate programming
8. The green LED on the MiniProg1 blinks to indicate the progress of programming
9. After successful programming, the red LED on MiniProg1 is powered off
10.Select the Toggle Power button in PSoC Programmer to power the board and verify output
File Load
Program
Toggle Power