Specifications

CY3214-PSoCEVALUSB Kit Guide, Doc No. 001-67030 Rev. *B 15
3. Kit Operation
3.1 Introduction
The CY3214-PSoCEVALUSB kit examples helps you to exchange data between a PC application
and real world I/O. The kit includes a full-speed USB User Module with programmable I/O user
modules to provide instant connection.
3.2 Square Mouse Example
The Square Mouse example is programmed to the CY3214-PSoCEVALUSB board as a default
project for demonstration purposes. If the PSoC on the board has been reprogrammed or erased,
follow the steps in the section, Programming Specifications and Connections on page 16 to program
the board with the square mouse hex file provided in the kit CD (
<Install_Directory>:\
Cypress\CY3214-PSoCEVALUSB\<version>\Firmware\squaremouse2_reset.hex).
To execute the program, follow these steps:
1. Connect the USB2 cable to the Mini USB type B connector on P1, as shown in Figure 3-1.
Ensure that the power selection jumper (shunt) is place on the first two pins (designated as
VBUS).
2. The message ”PSoC Eval USB 1” is displayed on the LCD.
3. Check the movement of the mouse pointer on the screen; note that it moves in a square fashion.
Figure 3-1. USB Cable Connection and Power Jumper Setting