User`s manual

Appendix B—Manufacturer’s Cross Refer-
ence vs Menu Selection
GTEK believes that the information contained in this list is correct.
However, GTEK assumes no responsibility or liability for the
accuracy of this list. Notes, if any, about the particular part are at
the end of this section.
The “Menu” column contains the command that you would send
to the programmer to select the part in question. A small “m” is the
“menu” command for the programmer, which is followed by the
letter (or period [.] then letter) to select the part. If a particular
algorithm is suggested, a toggle command is issued afterwards.
When you type this at the programmer command prompter, do not
put the comma! The comma is necessary if you are at the DOS
command line. Examples follow:
In the manual an AMD 27512 is shown under the “Menu” selection
as M7,TI
From Programmer command line after power–up to select
AM27512:
<xxxx>M7
<q27512>TI
<i27512>_
From DOS (or Control–F command line):
Enter Command Line —>[M7,TI
<i27512>
Please take note that you did not have to hit the “Enter” key for
these commands to work. In the first example one could type
“M7TI” all at one time. Hitting “Enter” does not have any effect other
than causing the programmer to re–issue the command prompter
in response.
Use the program “SEARCHER.EXE” on the PGMX program disk you
may have purchased.
Model 9000 Appendix B
Page 53