User`s manual

Results in the programmer giving you a menu of parts to select from.

Refer to the appendix parts list for help in selecting the correct part. At

that time, enter the menu selection number and the prompter will reflect

the part number selection that you made.

C000

<i27128A>_

Results in the programmer giving you a 16 bit addition of all the 8 bit

bytes of all the part, without carry. Blank 27128s give you C000 for the

checksum.

i27128A>(control-F)

Control— generally means to press and hold the CONTROL key on

your keyboard and press a command letter. Valid command letters are

P, F and C. The ESCape key is also a valid control command key, but

you do not hold the control key down to press ESC. The ESC key is a

valid control character already. The escape control command may also

be obtained by pressing CONTROL [ on the IBM keyboard or by

holding down the ALT key and entering 027 on the numeric keypad.

Pressing and holding the CONTROL - C key for instance is represented

by a caret and the letter that must also be pressed, eg. ^ C.

The definitions of the CONTROL commands are:

^ P –start sending / stop sending (toggle) data simultaneously to the

printer.

^ F –enter a command line. Examples follow.

^ C –Abort most programmer commands and return to the DOS or

PGMX command prompter. This command will work even though you

may be in the process of programming, reading, verifying, etc., an

eprom in the automated (control-F) mode.

ESC or ^ [ - Escape from program. This command is used as an

alternative to control–alt–del and is not normally used. This is an

EMERGENCY command and the results could be unpredictable.

Model 9000 Commands Chapter 9

Page 39