User`s manual

Chapter 9, PGMX
Installation of PGMX
PGMX is a high speed communication program which runs on IBM
PC’s, XT’s, AT’s, PS/2 (any model) and most compatibles. It allows
flexible manipulation, transmission and reception of Intel HEX files and
binary files.
On the PGMX program disk you will have at least 3 programs:
PGMX.COM, PINSTALL.COM and GHEX.EXE. PGMX is the program
used to communicate with your 9000. PINSTALL is the program that
you must run to install the serial drivers in PGMX so that you can
communicate with the 9000. Other programs and document files are
provided to allow conversion from Motorola format to Intel hex and
other programs to split and interleave to and from 8, 16 and 32 bit binary
formats.
If you try to run the PGMX program without installing the serial drivers,
it will tell you to run the PINSTALL program. Remember that the PGMX
license is a single user license.
Insert GTEK program disk in drive A: and copy the programs to your
hard disk with:
C>COPY A:*.*
This will copy all the programs on the GTEK disk over to the subdirec-
tory that you are logged on to on your hard disk. If you don’t have a
hard disk, use DISKCOPY or COPY to the B: drive. Refer to the DOS
manual for specific instructions on using the COPY command. The
desired end result is a backing up of the original GTEK copy. Store the
original program disk in a safe place.
Now you should insert the backup copy in the drive A: and/or go to the
subdirectory where PINSTALL and PGMX are located. You must first
run the PINSTALL program to install the serial drivers for PGMX.
C>PINSTALL<cr>
You are first asked for the name of the program you wish to install. In
most cases you would respond by typing PGMX. Next, you are asked
to select a letter which corresponds to the type of installation you wish
to perform.
Model 9000 Commands Chapter 9
Page 35