Datasheet

CY7C1513JV18
CY7C1515JV18
Document Number: 001-12560 Rev. *F Page 5 of 24
DOFF
Input DLL Turn Off − Active LOW. Connecting this pin to ground turns off the DLL inside the device. The
timings in the DLL turned off operation differs from those listed in this data sheet. For normal operation,
this pin is connected to a pull up through a 10 KΩ or less pull up resistor. The device behaves in QDR I
mode when the DLL is turned off. In this mode, the device can be operated at a frequency of up to 167
MHz with QDR I timing.
TDO Output TDO for JTAG.
TCK Input TCK Pin for JTAG.
TDI Input TDI Pin for JTAG.
TMS Input TMS Pin for JTAG.
NC N/A Not Connected to the Die. Can be tied to any voltage level.
NC/144M N/A Not Connected to the Die. Can be tied to any voltage level.
NC/288M N/A Not Connected to the Die. Can be tied to any voltage level.
V
REF
Input-
Reference
Reference Voltage Input. Static input used to set the reference level for HSTL inputs, outputs, and AC
measurement points.
V
DD
Power Supply Power Supply Inputs to the Core of the Device.
V
SS
Ground Ground for the Device.
V
DDQ
Power Supply Power Supply Inputs for the Outputs of the Device.
Pin Definitions (continued)
Pin Name I/O Pin Description
[+] Feedback