Specifications
Chapter 2: Board Components 2–37
Components and Interfaces
August 2012 Altera Corporation 100G Development Kit, Stratix V GX Edition
Reference Manual
Table 2–30 lists the SFP+ interfaces component reference and manufacturing
information.
CFP Interface
The CFP interface consists of 10 full-duplex transceiver channels. The CFP interface
can support both telecom and datacom applications such as Fibre Channel, Gigabit
Ethernet, ATM, and SONET/SDH.
Table 2–31 lists the pin assignments for the CFP interface and their corresponding
schematic signal names and Stratix V GX pin numbers.
13
SFP3_RDP
1.5-V PCML C4 Received data (output from the SFP+ interface)
9
SFP3_RS1
2.5-V LVCMOS AG33
Rate select. Controls the SFP+ interface transmitter.
When input signaling is high, the rate is > 4.25 GBps
and when input signaling is low, the rate ≤ 4.25 GBps.
19
SFP3_TDN
1.5-V PCML D5 Transmitted data (input to the SFP+ interface)
18
SFP3_TDP
1.5-V PCML D6 Transmitted data (input to the SFP+ interface)
3
SFP3_TXDISABLE
2.5-V LVCMOS AH10 Turns off and disables the transmitter laser output
2
SFP3_TXFAULT
2.5-V LVCMOS AU22 Interface transmitter fault
Table 2–29. SFP+ Interface Pin Assignments, Schematic Signal Names, and Functions (Part 3 of 3)
Board
Reference
(J10)
Schematic Signal
Name
I/O Standard
Stratix V GX
Device Pin
Number
Description
Table 2–30. SFP+ interfaces Component Reference And Manufacturing Information
Board
Reference
Description Manufacturer
Manufacturing
Part Number
Manufacturer
Website
J10 SFP+ host connector Samtec MECT-110-01-M-D-RA1 www.samtec.com
Table 2–31. CFP Interface Pin Assignments, Schematic Signal Names, and Functions (Part 1 of 4)
Board
Reference
(J25)
Schematic Signal
Name
I/O Standard
Stratix V GX
Device Pin
Number
Description
41
CFP_GLB_ALRM
2.5-V LVCMOS AR9
Global alarm.
0: Alarm on in MDIO alarm register
1: Alarm off
38
CFP_MOD_ABS
2.5-V LVCMOS AR20
Module absent.
0: Module present. Pull-up resistor on the host
1 or NC: Module absent
37
CFP_MOD_LOPWR
2.5-V LVCMOS AW37
Module low-power mode.
0: Power-on enabled
1 or NC: Module in low-power (safe) mode
39
CFP_MOD_RST
2.5-V LVCMOS AH34
Module reset.
0: Reset
1 or NC: Module enabled. Pull-down resistor on
the module