User guide

41
Altera FPGA + Cypress PSoC EVK
Cytech Technology, Ltd.
Cyctech’s “Altera FPGA + Cypress PSoC EVK” is a
starter kit for Altera Cyclone III FPGA and Cypress
PSoC1. The kit provides a set of low cost, easy and
convenient tool for learning FPGA and PSoC and for
R&D using FPGA and PSoC.
Features
• Altera
 Cyclone III FPGA EP3C5E144C8
 Configuration ROM EPCS4SI8
• Cypress
 CY8C24894-24LFXI
 CY7C1041DV33-10ZSXI
 CY25701
• PSoC + FPGA + SRAM integrated
• CapSense
 Three CapSense Buttons
 One CapSense Slider
• User Interfaces
 Two 7-Segment LEDs
 Buzzer
 2 Switches
• ADC simulation on board
• External Interface
 I2C / SPI
 JTAG
 USB
 UART
 GPIOs pulled out
• Documentation and support deliverables
 Schematics
 PCB data
 BOM list
 User guide Firmware sample source code
Galaxy NIOS Starter Kit
Galaxy Far East Corp.
Beside FPGA device, Altera provide IP &
development system for FPGA design, the Nios II is a
32 bit embedded processor, through Altera’s SOPC
(System on programmable Chip) Builder software,
designer is very easy to integration Altera’s IP such
as embedded processor, DDR/DDRII SDRAM memory
interface, UART, LCD module, timer and so on. Just
pickup IP of SOPC Builder and few setting, the
integration IP process is completed. The SOPC Build
is connecting all IP interfaces, locating address range,
assigning interrupt number, generating control logic
and basic simulation model, OS and software driver
automatically. Completing a system level hardware
design need 10 minutes time only.
Features
• Altera
 Cyclone II FPGA EP2C20F484C8
• 16M Bytes SDRAM Memory (MT48LC4M32B2)
• 8 M Bytes Flash Memory (AM29LV065D)
• 2X16 Character LCD Module
• PS2 Keyboard Interface
• RS232 Serial Communication Port
• 4 Bits DIP Switch
• 5 Push Button Switchs
• 8 LEDs
• 50 Mhz Oscillator
• Provide 185 In/Out Pin & 128 shareable In/Out Pin
• Galaxy USB Blaster
• USB Cable
• Module Board Size : 111mmX90mm
• Extender Board Size: 221mmX172mm
• Board size: 130mm x 90mm