User`s manual

Windows Installation

When you are ready to register, click Start | All Programs | Innovative |

<Board Name> | Applets. Open the New User folder and launch

NewUser.exe to start the registration application. The registration form

to the left will be displayed.

Before beginning DSP and Host software development, you must

support will not be provided until registration is successfully

completed. Additionally, some development applets will not operate

until unlocked with a passcode provided during the registration

process.

It is recommend that you completely fill out this form and return it to

Innovative Integration, via email or fax. Upon receipt, Innovative

Integration will provide access codes to enable technical support and

unrestricted access to applets.

Figure 4. ToolSet registration form

Bus Master Memory Reservation Applet.

At the conclusion of the installation process, ReserveMem.exe will run

(except for SBC products). This will allow you to set the memory size

needed for the busmastering to occur properly. This applet may be run from

the start menu later if you need to change the parameters.

For optimum performance each Matador Family Baseboard requires 2 MB

of memory to be reserved for its use. To reserve this memory, the registry

must be updated using the ReserveMem applet. Simply select the Number

of Baseboards you have on your system, click Update and the applet will

update the registry for you. If at any time you change the number of boards

in your system, then you must invoke this applet found in Start | All

Programs | Innovative | <target board> | Applets | Reserve Memory.

After updating the system exit the applet by clicking the exit button to

resume the installation process.

Figure 5. BusMaster configuration

At the end of the install process, the following screen will appear.

X5-GSPS User's Manual 18