User`s manual

Windows Installation
Starting the Installation
To begin the installation, start Windows. Shut down all running programs and disable anti-virus software. Insert the
installation DVD. If Autostart is enabled on your system, the install program will launch. If the DVD does not Autostart,
click on Start | Run... Enter the path to the Setup.bat program located at the root of your DVD-ROM drive (i.e.
E:\Setup.bat) and click “OK” to launch the setup program.
SETUP.BAT detects if the OS is 64-bit or 32-bit and runs the appropriate installation for each
environment. It is important that this script be run to launch an install.
When installing on a Vista OS, the dialog below may pop up. In each case, select “Install this driver software anyway” to
continue.
Figure 1. Vista Verificaton Dialog
The Installer Program
After launching Setup, you will be presented with the following screen.
X5-GSPS User's Manual 15