User guide

RS Embedded Development Platform (EDP)
Interface Modules
Processor Modules
Memory, Micros, Embedded Computing & Peripherals
ORDERLINE
65 6865 3433
28
Visit our website for additional price information and exciting promotions
MicroUSB, USB to RS232 Bridge Module
Ser-to-Eth Gateway - Module w/PCB pins
Serial-to-Ethernet Gateway w/Connectors
EDP 4-Module Motherboard
EDP 2-Module Motherboard
EDP LPC1113 Processor Module
mbed LPC1768 Module
WIZnet Inc
WIZnet Inc
This Embedded Development Platform (EDP) Baseboard (or
“motherboard”) consists of two "stations", with a minimum
configuration of motherboard with a single plug-in processor
module. Both stations are identical, and there are many
permutations of processor modules and application modules
possible. Even with just the minimum configuration you can
easily run a web-server through the standard on-board
Ethernet connection.
mbed is a tool for rapid prototyping with microcontrollers. A
special feature is on-line code compilation available from
the mbed website http://mbed.org when registered.
The Embedded Development Platform (EDP) Baseboard (or
“motherboard”) consists of four "stations", with a minimum
configuration of motherboard with a single plug-in processor
module. All four stations are identical, and there are many
permutations of processor modules and application modules
possible. Even with just the minimum configuration you can
easily run a web-server through the standard on-board
Ethernet connection. The more advanced user will discover
that it is possible to run more than one EDP processor
Embedded Development Platform (EDP) Processor module
for the NXP LPC1113 ARM Cortex-M0 microcontroller
including support devices. These 32-bit devices combine the
cost benefits of 8-bit and 16-bit devices with the flexibility and
performance of 32-bit devices at extremely low power
consumption. The architecture delivers state of the art
implementations for FPGAs and SoCs. With the Thumb
instruction set, Cortex-M0 based microcontrollers support a
4GB address space, provide bit-addressing (bit-banding), and
several interrupts with at least 8 interrupt priority levels.
Classification Module
Technology Ethernet
A USB to RS-232 bridge converter which is simple, very small and
easy to use. It uses a mini-B type USB connector to connect to a
PC and is based on the CP2102 Bridge from Silicon Labs. It
provides the user with multi baud rate serial data and access to
flow control signals in a convenient 10 pin 0.1” pitch Dual-In-Line
package.
WIZnet’s WIZ110SR Serial to Ethernet Gateway
module features:
Complete Serial to Ethernet module for simple and
50MHz LPC1113 CPU with 24kB on-chip FLASH memory and 8kB SRAM
DP83848 PHY Ethernet interface
Micro-SD card slot
Description Stock no. Price
per
OM S$ S$ S$
One-Port Serial-to-Ethernet
Device Server
708-0000
a unit 1+ 250·00 5+ 240·00
Two-Port Serial-to-Ethernet
Device Server
708-0012
a
unit 1+ 335·00
12Mbps maximum speed
Hardware or Xon/Xoff handshaking supported; 300bps to
1Mbps
UART supports 5-8 bit data, 1-2 Stop bits, odd/even and no
parity
Integrated EEPROM
On-chip 3.3V regulator available
Power on reset circuit
Supports Windows, MAC (OSX-9 and above) and Linux (2.4
module on the motherboard in a Master and Slave configuration.
+12V supply input, connection by DC jack or screw connector, optional fuse holder
Fitted +3.3V and +5V linear voltage regulators
RJ-45 Ethernet connector with magnetics and LEDs
Mini-USB debug connector
System reset button
I/O breakout headers
Optional 8 x DIP switches ported onto the system I
2
C bus
Optional serial I
2
C EEPROM
Up to three I
2
C buses and two CAN networks are available (processor dependent)
Cortex-M3 Core LPC1768 microcontroller, 96MHz with
512KB Flash memory, 64KB RAM
Ethernet, USB, CAN, SPI, I
2
C and GPIO interfaces
40-pin DIP format module, board size: 44mm x 26mm
Powered by USB or +4.5 to +9v applied to V
IN
Current consumption:
< 200mA ( ∼ 100mA with Ethernet
disabled)
Real-time clock battery backup input
+3.3v regulated output on V
OUT
to power peripherals
+5.0v available on V
U
(only when USB is connected),
limited to 500mA
WIZnet’s WIZ100SR Serial to
Ethernet Gateway module features:
Plug & Play Serial to Ethernet
Note: The EDP ARM debug module (RS Part No. 703-9241) is required to program/debug this module.
kernel and above)
Self powered or USB powered
Traffic/Operation LED indicates board status
Stock no. Price per OM S$ S$ S$
703-9232 unit 1+ 123·50
UDSx100 Serial-to-Ethernet Device
Servers
Standard Extended-Euro card size (220 x 100 mm) fitted with rubber feet
High-quality module connectors designed for multiple insertions/extractions
Optional 64-way DIN connector allows the board to be plugged into a rack-system backplane
+12V fused supply input with noise filter, connection by DC jack or screw connector
+3.3V and +5V switching regulators
Optional RTC back-up battery
RJ-45 Ethernet connector with magnetics and LEDs
Mini-USB debug connector
I/O breakout header
8 x DIP switches ported onto the system I
2
C bus
System reset button
4kbytes I
2
C serial EEPROM
Up to three I
2
C buses and two CAN networks are available (processor dependent)
Gateway module
High stability & reliability by using W5100 WIZnet Chip,
a fully-hardwired TCP/IP stack
10/100Mbps Ethernet Interface, Max. 230Kbps Serial
Interface
Compact size : 50mm X 30mm
Digital I/O pins are rated at: +3.3v, 40mA each, 400mA max
quick network implementation
High stability & reliability by using a W5100 WIZnet Chip, a fully-
hardwired TCP/IP stack
Easy and powerful configuration program
10/100Mbps Ethernet interface, Max. 230Kbps Serial interface
Manu. Part No. Stock no. Price per OM S$ S$ S$
UUSB-MB5 426-617 unit 1+ 66·50 5+ 61·50 20+ 58·00
Stock no. Price per OM S$ S$ S$
460-285 unit 1+ 285·00 2+ 280·00 5+ 275·00
Manu. Part No. Stock no. Price per OM S$ S$ S$
WIZ100SR 419-962
a unit 1+ 45·60 10+ 45·50 25+ 45·40
Network virtually any device
in minutes
Access, monitor and control
equipment over Ethernet
Replace dedicated PCs and/or
modem lines with fast and
reliable Ethernet networking
Note: A special adapter is available (RS Part no. 703-9235) to allow this module to work with the RS
Embedded Development Platform (EDP).
Manu. Part No. Stock no. Price per OM S$ S$ S$
WIZ110SR 419-968
a
unit 1+ 56·00 10+ 53·50 25+ 51·00
Stock no. Price per OM S$ S$ S$
703-9226 unit 1+ 122·00
Stock no. Price per OM S$ S$ S$
703-9238 unit 1+ 128·00
Configure quickly and easily via HTTP, DHCP, Telnet, serial or Lantronix DeviceInstaller
ᓽ
utility
Supports RS-232, RS-422 and RS-485 communications (Two DB9M DTE serial ports for UDS2100)
Environmentally-friendly RoHS and WEEE compliant
Features TruPort
ᓼ Com port control technology
Meets the UL 864 9th Edition standards (UDS1100)
797
www.nguyenxuong.com