User guide

C M M - 52259 J U N E 1 1 , 2 0 1 0
U S E R G U I D E
5
FEATURES
The CMM-52259 is full-featured, low-cost application module featuring the Freescale
MCF52259 microcontroller. This module is available in 3 configurations; the CMM-52259-
OEM consists of the board only, the CMM-52259-DEV consists of the board and supporting
cables, the CMM-52259-DEV-BDM consists of the board, supporting cables, and an AxBDM.
In default configurations, the board is built with only the BDM_PORT header installed. Re-
maining IO headers are left unpopulated. This provides the end-user flexibility to mount addi-
tional headers on either side of the board.
The board and BDM are fully compatible with Freescale CodeWarrior. The MQX RTOS is also
freely available for application development. Embedded application development and debug is
quick and easy using the CMM-52259-DEV-BDM, CodeWarrior, and MQX RTOS.
Features:
 MCF52259 CPU, 144 LQFP
 V2 ColdFire Core w/ eMAC
 80MHz internal bus
 512 KB FLASH
 64 KB SRAM
 4ch, DMA Controller w/ Timers
 10/100 Fast Ethernet Controller (FEC)
 USB Physical Layer Interface (PHY)
 Host/Device/OTG USB Modes
 Mini-FlexBus External Bus Interface
 Fast ATD Converter
 FlexCAN 2.0B Module
 I2C, UART(s), QSPI
 Real-Time Clock
 48 MHz and 32.768 KHz Crystal Input
 1Mb (128K x 8) Fast SRAM Memory
 64Mb Serial Flash Memory
 10-100 Ethernet PHY
 RJ-45 Connector w/ Magnetics
 HP Auto MDI/MDI-X Cable Detection
 SPD and LINK_ACT LEDs
 mini-AB USB Port
 Host/Device/OTG Modes Supported
 USB Mode Select Control
 Up to 500mA VBUS output
 Low- and Full-Speed USB Signaling Supported
 RS-232 Port w/ 2 x 5 Pin Header
 1 Mbaud CAN PHY
 IO Header Access to MCU Signals
 RESET switch input w/ indicator
 ABORT switch input
 On-board voltage regulators provide all operating voltages
Specifications:
Board Size 2.2” x3.5”
Power Input: +7 to +34 VDC, 9VDC typical