User guide

96 CY3687 MoBL-USB FX2LP18 Development Kit User Guide, Doc. # 001-68582 Rev. *B
MoBL-USB Development Kit Firmware Examples
18.A red breakpoint indication is seen in the margin next to the new breakpoint as shown in
Figure 8-32. Press RUN button as shown in Figure 8-33.
Figure 8-32. Breakpoint Indicator in Keil uVision2 IDE
Figure 8-33. Run button in Keil
19.Now press F3 on the development board (the KEY_F2 label equates to the F3 button). Program
execution halts in the Keil IDE and the LED does not increment.
20.Press Step Over as shown in Figure 8-34. Then press Run key again on the debugger.
Figure 8-34. Step Over Debug Button in Keil uVision2 IDE
21.Execution proceeds normally until F3 key is pressed on the development board again. When fin-
ished, press the Stop Debugging key and exit the Keil debugger.
Note: If the Keil debugging does not proceed then re-build the firmware project and redo steps
12-21


