User guide

CY3687 MoBL-USB FX2LP18 Development Kit User Guide, Doc. # 001-68582 Rev. *B 91
MoBL-USB Development Kit Firmware Examples
a. mon-int-sio1.hex: This keil debug monitor file resides in internal MoBL-USB RAM memory and
communicates through SIO-1 UART port.
b. mon-int-sio1.spt: This keil debug monitor script file resides in internal MoBL-USB RAM mem-
ory and communicates through SIO-1 UART port.
Copy latest version Keil debug Monitor DLL (ver 2.40) located at <Installed_directory>\<ver-
sion>\Target\Monitor\mon51 to C:\Keil\C51\BIN.The existing DLL can be saved elsewhere if
required. The latest Mon51.dll supports debugging on this CY3687 MoBL-USB FX2LP18 devel-
opment board.
7. Open Keil uVision2 IDE by selecting Start > Programs > Keil uVision2. Open the dev_io project
file at <Installed_directory>\<Version>\Firmware\dev_io, as shown in Figure 8-20 and
Figure 8-21.
Figure 8-20. Opening Project File using Keil uVision2 IDE
Figure 8-21. Selecting Project File using Keil uVision2 IDE
8. Make sure you are using the correct serial port and that the baud rate is set correctly. To do this,
select Project > Options for Target 'Target 1' > Debug > Settings.
Note: Your PC may have a single serial port. In this case, use relevant COM port by checking
under Ports (COM and LPT) in Device Manager (Type devmgmt.msc in Windows Start->Run)
as shown in Figure 8-22. Check the box labeled Serial Interrupt.

