User guide

CY3687 MoBL-USB FX2LP18 Development Kit User Guide, Doc. # 001-68582 Rev. *B 53
USB PC Host Utilities and SuiteUSB Applications
■ BulkTrans: This button is used transfer data over Bulk IN/OUT endpoints. After Bulkloop firm-
ware example is downloaded (Bulkloop.hex) this button is used to send data over Bulk IN/OUT
endpoints using Bulk Trans button. A sample demonstration is provided under section Bulkloop
Example on page 71. For more details on Cyconsole refer to CyConsole.chm/CyConsole.pdf at
C:\Cypress\Cypress Suite USB 3.4.7\CyConsole. A sample demonstration of this utility while
using firmware examples is provided in MoBL-USB Development Kit Firmware Examples chapter
on page 59 of this document.
■ FileTrans: This button is used to download raw packet data to MoBL-USB FX2LP18 device.The
sample files that could be used to transfer are available at <Installed_directory>\<Version>\Tar-
get\File_Transfer.
7.2.2 CyControlCenter Utility
The CyControlCenter performs functions similar to CyConsole application. Following are major func-
tions of CyControlCenter
Figure 7-3. CyControlCenter Snapshot for MoBL-USB FX2LP18 Device
■ Firmware Download: After connecting MoBL-USB FX2LP18 development board in SAFE
EEPROM mode (switch SW2 on board to SAFE) the firmware can be download to RAM, small
EEPROM or the large EEPROM.The procedure to download is explained in detail in MoBL-USB
Development Kit Firmware Examples chapter on page 59 for each of the firmware examples pro-
vided with the kit.