User guide

46 CY3687 MoBL-USB FX2LP18 Development Kit User Guide, Doc. # 001-68582 Rev. *B
Cypress USB Drivers for MoBL-USB FX2LP18 Kit
Figure 6-5. Script File Creation using CyScript Tool
Verify if the xx.spt file is located in the destination directory.This tool can only generate a script but
cannot play the script. Using Cyconsole or Controlcenter the generated script file can be loaded
and played to download the firmware inside the script.
6.3.1.2 Script File Generation and Play using CyConsole
Open Cyconsole tool located at C:\Cypress\Cypress Suite USB 3.4.7\CyConsole. Click
on C:\Cypress\Cypress Suite USB 3.4.7\CyConsole. Alternately the tool can be accessed
at Windows Start->All programs->Cypress->Cypress SuiteUSB 3.4.7. Follow the below process
to generate and play the script.
Figure 6-6. Script Generation and Download Option in Cyconsole
1. Connect a USB A-to-B cable between Windows PC USB Host port and J2 connector on MoBL-
USB FX2LP18 development board.
2. The board should have switch settings SW2 = SAFE, SW1 = either position. The MoBL-USB
FX2LP18 device enumerates with default Connect mode EEPROM (U5) VID/PID.
3. Select Record Script button.In the options menu select EZ-USB Interface. Select Download in
the new pop up window and browse to Bulkloop.hex at <Installed_directory>\<Version>\Firm-
ware\Bulkloop
4. Observe the Bulkloop.hex file getting downloaded successfully to MoBL-USB FX2LP18 internal
RAM memory. After firmware download click Stop recording button and save the .spt file gener-
ated into the local directory of choice.