User guide

CY3687 MoBL-USB FX2LP18 Development Kit User Guide, Doc. # 001-68582 Rev. *B 13
Getting Started
9. GPIF designer software is triggered after keil installation.This software is used to create State
machine waveforms to communicate between MoBL-USB FX2LP device and devices such as
FPGA, Image sensors, FIFO, and so on. If the PC already has the software installed then the
installer will not trigger the installation. If the PC does not contain the software then GPIF
designer welcome screen appears as shown in Figure 2-8. Click Next.
Figure 2-8. GPIF Designer Welcome Window
10. Click Next in the subsequent windows and Finish window appears as shown in Figure 2-9.
Figure 2-9. GPIF Designer Welcome Window