User manual

Find product information and data sheets on www.keene.co.uk
3
Audio
Architectural Speakers for use
in Walls or Ceilings
• Pivotal tweeters allow high frequencies to be
focussed
• Removable mesh grills
• Frame allows for ceiling or wall board mount without
extra brackets
• 8 ohms
203mm Circular CMS5U
• Frequency response:
80Hz - 20kHz
• Power: 25W RMS
• Overall Diameter:
203mm
• Panel cut out: 165mm
• Sound pressure level:
89dB
273mm Circular CMS8U
• Frequency response:
60Hz - 20kHz
• Power: 30W RMS
• Overall diameter 273mm
• Panel cut-out 238mm
• Sound pressure level: 90dB
Code CMS5U £69.99
Code CMS8U £89.99
Digital In-Wall Slave Amplifier
If you are sending a line level signal to a room then
sometimes you'll have direct control of the source and
just want to amplify the audio signal in the room
without needing any other form of control. The Keene
KLAB20DS slave amplifier will do this job perfectly. It is
designed to be a fit and forget solution to powering
additional and remote pairs of loudspeakers. Once
installed it will automatically switch on whenever audio
is detected and switch back again to an ultra-low
power standby mode when no audio signal is present.
Ideal for feeding line outputs from from say
Squeezebox, Sonos etc.
Code KLAB20DS (Amplifier only) £109.99
Code KLABKITDS (Amplifier & PSU) £129.99
Code KLABPSU (15v DC 4A power supply) £29.99
Moisture Resistant Speakers
for use in Walls or Ceilings
High quality moisture resistant speakers suitable for PA
installations in swimming pools, bathrooms, shower
rooms, saunas and tanning rooms etc.
148mm Circular CMS5MR
• Frequency response:
80Hz - 20kHz
• Power: 35W RMS
• Overall Diameter:
148mm
• Panel cut out: 112mm
• IP35 rated
180mm Circular CMS8MR
• Frequency response:
80Hz - 20kHz
• Power: 40W RMS
• Overall Diameter:
180mm
• Panel cut out: 132mm
• IP35 rated
Code CMS5MR (per pair) £34.99
Code CMS8MR (per pair) £39.99
254mm Square B414C
• Frequency response:
40Hz - 20kHz
• Power: 90W RMS
• Overall Dimensions:
254x254x87mm
• Cut-Out Dimensions:
219x219mm
• Moisture Resistant Design
Subwoofer B403A
• Frequency response:
30Hz - 4kHz
• Power: 220W (max)
• Overall Diameter: 268mm
• Panel cut out: 232mm x 177mm
deep
• Impedance 8 Ohms
• Moisture Resistant Design
Code B414C (per pair) £39.99
Code B403A (single speaker) £27.99
PACKAGE DEAL
Amplifier kit with
Speakers Special Offer
KLABKITD plus a pair of CMS5U
Code KLAB20DC5 £189.99
KLABKITD plus a pair of CMS8U
Code KLAB20DC8 £229.99
Rectangular B411A
• Directable Titanium dome
tweeter
• Power: 50W RMS
• Overall Dimensions:
305x218x77mm
• Cut-Out Dimensions:
275x185mm
• Frequency response: 80-20kHz
Rectangular Subwoofer B415A
• Frequency response:
30Hz - 3kHz
• Power: 90W RMS
• Overall Dimensions:
367x367x88mm
• Cut-Out Dimensions:
329x329mm
• Impedance 8 Ohms
Code B411A (per pair) £34.99
Code B415A (single speaker) £34.99
Single Speaker with
Dual Coil & Stereo
Connections
Ideal for smaller
installations where you
don't really have the
room or need to fit
two loudspeakers, this
provides both left and
right stereo channels
from a single point,
whilst maintaining
channel separation.
The speaker has twin
connections so you
simply run both left
and right speaker
cables to it.
• Frequency response:
70Hz - 20kHz
• Power: 25W + 25W RMS
• Overall Dimensions: 227x86mm
• Cut-Out Dimensions: 193mm
• Impedance 2 x 8 Ohms
Code CMS65S (single speaker) £29.99
Bookshelf Speakers
High quality 4" dual cone,
full range mini box speakers.
Solid ABS Construction with
Quick Connect Speaker
Terminals.
• 4" Full Range Mini Box
Speaker System
• Dual Cone Full Range Speakers
• 12 Oz Shielded Magnet
• Power 80 W Max
• Quick Connect Speaker Terminals
• Dimensions (mm) 120x120x132
• Impedance 8 Ohms
• Power 40W RMS
• Frequency Response 80Hz-20kHz
Code B406A BLACK (per pair) £18.99
Code B405A WHITE (per pair) £18.99
HQ Wall mounted loudspeaker
volume control
Suitable for UK standard electrical double pattresses
(47mm deep). White facia with chrome colour knob.
High efficiency (transformer) design with max power
handling of 60W rms. Will accept cable up to 2.5mm
dia. Connect in-line between amplifier and speaker.
Code BT936 £ 24.99
117657_Connections_October_2014.indd 3 16/10/2014 11:21