User manual

Find product information and data sheets on www.keene.co.uk
29
IR & AV Cables
CAT5 Cable Economisers
Although CAT5 cables have four pairs of conductors, 10base
and 100base systems only use two of these pairs so half of
the cable is redundant. These cable economisers allow you to
route two IP signals down a single Cat5 cable. Ideal for use
with the IR Anywhere modules as it allows you to add remote
control without having to utilise an extra remote network
hub or switch. Supplied in pairs.(Note: CANNOT be used with
Gigabit networks or anything using POE!)
IR Link Cables
For direct connection of the IR Wand output to the IR
receiver input on a Keene IR Distribution Amplifier.
CAT5 Cable Receiver Extenders
If the Jack cable extenders aren't long enough or you
already have some installed CAT5 cable you'd like to use
then these will solve the problem. This kit consists of a pair
of short (25cm) line adaptors, one with an RJ45 line socket
to a 3.5mm stereo jack plug, and the other with an RJ45
line socket to a 3.5mm stereo jack socket. To use simply
plug the IR receiver in to the 3.5mm jack socket of one
adaptor and the 3.5mm plug of the other adaptor goes
into the IR receiver input of your IRBKIT or IR Commander.
Connect your Cat5/6 (standard wired network cable) in
between the adaptors and that is it. Using this method it
is possible to remote mount IR receivers at distances of up
to 100m.
Code KA175 £ 5.99
Code KA201 £ 19.99
Code KLDE10M 2.5mm to 3.5mm tip & ring
connected only £5.99
Code KLDE6M 3.5mm to 3.5mm tip and ring
connected only £5.99
Jack Extension Cables
Extension leads, 3.5mm stereo jack plug to 3.5mm
stereo socket to be used on input or output as
required. We’ve tested the input up to 10m and the
output to 20m.
Code KLD40 3M £4.49
Code KLD405 5M £4.99
Code KLD4010 10M £8.99
Extra Long CAT5 Cable Receiver
Extenders
If you need to extend even further then the new KA175XLE
uses a line driver meaning you can extend by up to a full
305m reel of CAT5 cable!
Code KA175XLE £ 19.99
Kramer BNC Cables HD SDI
These cables are constructed of high performance RG-6 cable
with 75 ohm BNC connectors at each end. They offer
outstanding quality, durability, and high performance for any
video signal application including HD-SDI signals. High
quality connectors - True 75 ohm BNC connectors maintain
correct impedance .
Specifications
• Conductor: 18 AWG solid bare copper.
• Dielectric: Skin Foam.
• Outside Jacket Color: Dark gray w/white lettering.
• Outside Jacket: PVC.
• Shield: (A) 61% braid aluminium wire 34 AWG.
• (B) dual-foil/mylar 25% overlap rate.
• Center Conductor: 0.0403 inches, 1.02mm.
• Dielectric: 0.179 inches, 4.57mm.
• Outside Diameter: 0.391 inches, 6.95mm.
Code SBB801 0.5M £2.73
Code SBB802 0.9M £3.12
Code SBB803 1.8M £3.90
Code SBB804 3.0M £4.68
Code SBB805 4.6M £5.45
Code SBB806 7.6M £7.79
Code SBB807 10.6M £9.74
Code SBB808 15.2M £12.47
Code SBB808 15.2M £12.47
Code SBB809 22.9M £17.14
Code SBB810 30.5M £21.82
Code SBB811 45.7M £30.39
3 BNC TO 3 BNC RGB
COMPONENT CABLE
High quality three BNC plugs to three BNC plugs.
Gold plated connections.
Application: RGsB or component video
Code SBB301 1.0M £28.59
Code SBB302 2.0M £29.99
Code SBB304 5.0M £39.99
Code SBB305 10.0M £49.99
3 PHONO TO 3 PHONO RGB
COMPONENT CABLE
High quality three RCA phono plugs to three RCA phono
plugs.
Gold plated connections.
Application: RGsB or component video
Code SBB101 1.0M £29.99
Code SBB102 2.0M £34.99
Code SBB104 5.0M £39.99
Code SBB105 10.0M £49.99
3 BNC TO 3 PHONO RGB
COMPONENT CABLE
High quality three BNC plugs to three RCA phono plugs.
Gold plated connections.
Application: RGsB or component video
Code SBB201 1.0M £29.999
Code SBB202 2.0M £34.99
Code SBB204 5.0M £39.99
Code SBB205 10.0M £49.99
This is just a tiny fraction of the
many analogue and digital cables we
are able to supply. Please call or visit
www.keene.co.uk for more details
117657_Connections_October_2014.indd 29 16/10/2014 11:21