Specifications

CAK50/CAK61 SERIES ERROR! USE THE HOME TAB TO APPLY 标题 1 TO THE TEX
SHENYANG MACHINE TOOL CO., LTD 14
 During handling, a great attention should be paid to avoid the NC system and
high-pressure switchboard to be shocked. Before handling the machine, check if every
part is stable or movable, whether there is an article that is not allowed to be put on the
machine.
The requirements mentioned below should be followed during handling the
machine：
The protection door should be first fixed when the machine is transported. On both sides
under the protection door there are two screw holes of M6. Make the screws of M630 of
the dog on the guideways be fixed with the protection door. And the pieces, on the edge
of the protection door, used for transportation make the door be connected and fixed with
the rear protection position. To lift the machine packed in wooden case by a crane, strong
steel wire rope should be looped in the rope marks pointed lateral side of the case. When
transporting and unloading the case, bumping and shocking should be avoided. Over
inclination of packing case is prohibited, otherwise, the accuracy of the machine will be
badly affected even damaged. If rolls are used for the transport of the case, it is important
that the inclination of condition of the slips should not exceed 15° and the diameter of the
rolling rod should not be more than 70 mm. Never place the case on a prismatic body or
upside down to avoid accuracy of the machine to be affected.
When the machine is unpacked, first inspect its exterior condition and check attachments
according to the “Packing List”.
When using a crane lifts the unpacked machine, make the steel wire rope pass through
the first and the third (for L=1900, it should be the fourth) rib holes on the front of the
bed (see Fig.1-1) and by the help of the carriage and the tailstock to balance the machine
to be lifted. Before the machine is lifted, wooden blocks should be padded between the
strong steel wire rope and the machine or the steel wire ropes are slipped with rubber
pipes to prevent the machine and the protection plate from scratching.
 The machine should be kept balance in both horizontal and vertical during handling,
so, at the very beginning when the machine being handled up the machine should be
kept balance.
 The angle of the handling rope is no more than 60°.
 Whenever more than one person carries out the handling work, signals should be used
between each other for coordination.
3.4 How to Install the Machine
The performance of a machine is greatly influenced by the installation way. If the
guideways of a machine are finishing machined, but the original accuracy cannot be
reached due to the reason of bad installation of the machine. And most troubles of the
machine were caused by this reason.