Specifications

CAK50/CAK61 SERIES ERROR! USE THE HOME TAB TO APPLY 标题 1 TO THE TEX
SHENYANG MACHINE TOOL CO., LTD 11
3 HANDLING AND INSTALLATION
3.1 Transportation and Storage of the Machine
Measures for corresponding anti-damp, anti-vibration and anti-impact had been taken
during the packing of the machine, guaranteeing the machine can be transported and
stored under the temperature of -25C~+55C, and the highest resistible temperature is up
to 70C during the short-period transportation and storage within 24h.
3.2 Preparation before Installation
3.2.1 Ambient Requirement (for Machine)
The machine shouldn’t be installed in the positions listed below：
 The ambient temperature can obviously change. For example, the machine’s installing
position has direct heat resource or is close to the heat resource.
 Over-wet place.
 Too dust, too dirty place.
 Near the vibration resource.
 The floor for installing the machine is not strong enough or soft.
Notice：
 If the machine has to be installed near the position with vibration resource, dig a canal
around the machine or make similar measures for anti-vibration.
 If the machine has to be installed on the soft soil, it is necessary to use the pile way or
similar measures to increase the force of the soil support, so that the machine will not
sink or incline.
3.2.2 Ambient Requirement (for NC)
 Ambient temperature: 5  40°C (under working condition)
 Relative humidity in normal case： Lower than 75%
3.2.3 Power Interface
Terminal block is located at side of the front leg of the machine.
3.2.4 General Power Supply
Prepare the power supply cable and earthing wire according to main power supply
specified by the Table for Control Parameters of the Machine. For the details, please
refer to
《INSTRUCTION BOOK for Electric Unit》.
3.3 Handling
For handling plan, please refer to Fig. 1 – 1, 1-2