Specifications

CAK50/CAK61 SERIES ERROR! USE THE HOME TAB TO APPLY 标题 1 TO THE TEX
SHENYANG MACHINE TOOL CO., LTD 8
 Back all parts of the machine to their original positions.
 Check the chip scraper to see if it is damaged, and replace it with a new one if
it’s damaged.
 Check if the coolant, hydraulic oil and lubricating oil are dirty, and if the
pollution is serious, change it with the new.
 Check the amount of coolant, hydraulic oil and lubricating oil, and add them
when necessary.
 Clean the filter of the water tank.
 Before leaving from the machine, turn off the switch of power supply on
operating pendant as well as the switch of main circuit and main switch of the
machine.
2.11 Safeguard Devices
 Front and back protection devices and coolant protection device.
 Overtravel limitation switch
 Protection device for chuck, tailstock and tool (NC software is set by user
parameters).
 Store travel limit (NC software)
 Emergency stop button
2.12 Preparation before Maintenance
Warn:
 Any maintenance cannot be done without authorization.
 Replacement of parts, wearing parts (seal, oil seal, O-type ring, bearing, grease
and oil) should be made according to preplan.
 Prepare record, preventive measures and correct maintenance method.
Notices:
 Carefully read and be acquainted with the safeguard measures specified in the
INSTRUCTION BOOK.
 Read the INSTRUCTION BOOK carefully and thoroughly and be acquainted
with the relative principle, structure and notices included in the Book.
2.13 Maintenance Operation
Danger：