Specifications

CAK50/CAK61 SERIES ERROR! USE THE HOME TAB TO APPLY 标题 1 TO THE TEX
SHENYANG MACHINE TOOL CO., LTD 7
 During heavy cutting, hot chips may cause fire, so preventing chips from
congestion is necessary.
Warn:
 When operating the machine, operate the switches without gloves to avoid
mis-operation.
 Workpiece can be unloaded only when the tool and spindle are under stop status.
 Cleaning chips is forbidden during cutting.
 It is forbidden to open the safeguard door when the machine is running.
Notice:
 When moving heavy workpiece, more than two people must work together to
ensure safety.
 The operators who use fork-type lifter, crane or other similar equipment must
have been professionally trained and have been granted concerned certificate.
 Whenever operating the fork type lifter, crane or other similar equipment, great
attention should be paid to avoid collide with other devices around.
 The steel wire or hook being used for handling must have enough strength to
satisfy the requirement of loading, and they must be limited within the safe rules.
 Do not clean chips on the cutter by bare hand, but use brush to clean it.
 Mounting and dismounting tools should be done only when the machine is under
stop status.
 Operator should wear anti-gas mask when machining the workpieces made from
magnesium alloy.
2.9 Machining Interruption
Notices:
After machining, before leaving from the machine, the operator have to turn off the
switch of power supply on the operator’s panel as well as the switch of main circuit.
2.10 After Turning
Notices:

Cleaning is forbidden before stopping the machine.
 When the machining is ending, remove the chip and clean the door, window and
cover. The iron chip should be cleaned by special hook or other implement,and it
should not be cleaned by hands directly.