Specifications

CAK50/CAK61 SERIES ERROR! USE THE HOME TAB TO APPLY 标题 1 TO THE TEX
SHENYANG MACHINE TOOL CO., LTD 6
 If the machine has been stopped for a long time, you’d better not start the
machine with actual machining otherwise which may damage the sliding parts
because of the lubrication is not sufficient. For this reason the machine parts may
get heat expansion to affect the machining accuracy. In order to avoid this
situation the machine temperature should be raised.
2.7 Preparation before Starting the Machine
Warn:
 Tooling should be in accordance with the technical parameters, size and type of
the machine.
 Excessive wear or damage of tools will influence the working accuracy directly or
damage the machine, so new ones should replace excessive worn tools
beforehand.
 For the convenience of safe check, the working area should have good
illumination.
 Tools or other things around the machine or equipment should be arranged in
perfect order and keep the environment tidy and the path unlocked.
 Tools and other things cannot be put on the headstock, turret, covers or other
similar positions.
 If the center hole of a heavy cylindrical workpiece is too small, the workpiece
may skip out of the center when it is loaded, so, pay attention to the size and
angle of the center hole.
Notice:
 The length of workpiece should be limited within the specified range to avoid
interference.
 After the tools are set, trail run should be performed first.
2.8 Matters Needing Attention during Operation
Danger ：
 Long hair should be covered with cap when operating the machine.
 Workpiece must be chucked tightly.
 The adjustment of the nozzle of the coolant is permissible only when the machine
is under stop status.
 During machining, it is forbidden to touch workpiece or spindle by hand or
under other modes.
 Do not open the door of machine during automatic machining.