Specifications

CAK50/CAK61 SERIES ERROR! USE THE HOME TAB TO APPLY 标题 1 TO THE TEX
SHENYANG MACHINE TOOL CO., LTD 5
 The oil tank of the machine should be filled to the oil level, and check it, refill it if
necessary.
 For lubricating point, the kind of oil and relative oil position, please refer to their
concerned labels.
 Every switch and operating lever should be nimble, smooth and the actions
should be checked.
 When you supply power to the machine, switch on the factory electrifying switch,
main circuit switch and power supply switch (make them at Positions “ON”) on
the operator’s panel in turn.
 Check the amount of coolant; and add it when necessary.
2.4 Requirement after Switching on the Power Supply
When the switch of power supply on the operator’s panel is set to ON, check if the
indicating lamp READY is light or not.
2.5 Normal Inspection
Warn：
Never insert your finger in-between the pulley and belts when you check the tension
of the belts.
Notice：
 Check if the reading on the pressure meter is correct.
 Check if there is any abnormal noise coming from motor, gearbox or other parts.
 Check the lubrication state of sliding parts.
 Check if the safeguard device or protective cover is under good status.
 Check the tension of the belts. If they are too loose, replace them with new
matchable ones.
2.6 Temperature Raising
Notices：
 When you raise the temperature of the machine, especially for spindle and feed
shafts, the machine should run at half or one-third of max. speed for 10-20
minutes under automatic mode so that the stable temperature required for the
machine can be reached.
 Under the automatic mode, every action of the part should be carried out
according to the program. At the same time, the action status of each part shall
be checked.