Specifications

CAK50/CAK61 SERIES ERROR! USE THE HOME TAB TO APPLY 标题 1 TO THE TEX
SHENYANG MACHINE TOOL CO., LTD 4
the machine will occur.
 Don’t change parameters or other electric devices at will. If it must be changed,
you should register the original value before change, so that it can recover to the
original value when needed.
 Do not dirty nick or get down any caution label. If the words on it are not clear or
lost, order a new one from our Works.
 Enough working space should be given to avoid accident.
 Oil or water can make the floor slipping to cause danger. So, always keep the
floor clean and dry to avoid accidents.
 Confirm the switch that you are going to use, don’t mistake.
 Never touch switches at will.
 The worktable near the machine should be very strong and stable to prevent
something from sliding down from it.
2.3 Requirement Prior to Switching on the Power Supply
Danger：
All cables, wires or patch cord whose insulating covers are damaged will cause
current leakage or shock, so it is necessary to check them carefully before use.
Warn：
 It is necessary to understand all the details specified in the Instruction Book and
Programming Manual, and make clear for every function and operation
procedure.
 Wear the insulating shoes, overalls and other articles for safeguard.
 Close the doors and covers of NC unit, operation panel and electric control panel.
Notices：
 The cables used from electrifying switch to the switch for general power supply
of the machine should have enough section to meet the requirements of electric
power.
 The cables set on the floor must have the ability of chip proof to avoid short
circuits.
 Before starting the machine for the first time after unpacking the wooden cases
or start the machine after a long-time stop of the machine, it is necessary to oil
the sliding parts with new lubrication oil, the lubrication pump should
continuously work until the oil seeps from chip scraper.