Specifications
4
3. Manual EDID: Support independent EDID by appoint input
and output ports.
B. IP
1. IP address,
2. Netmask,
3. Gateway.
C. Temperature
1. Temperature 1,
2. Temperature 2, these gures shows the temperature of the
device inside.
6
ALL: Press this button to select all outputs with one input.
7
0~9: Press these numbers when selecting input output ports.
8
OUT/IN: Press this button to select input source to displaying on
output display. The sequence should be OUT/IN
→
number(s) for
input source
→
OUT/IN
→
a number for output display
→
Enter.
9
+: Press this button when selecting more than one output for an
input selection. (This button works only under OUT/IN function)
10
LOCK & LED: Press this button to lock all the function buttons on
panel. The LED will illuminate, to unlock press it again.
11
SAVE: Press this button to save the present setting of the I/O. There
are 3 sets available for saving.
12
RECALL: Press this button to recall from the saving settings of 1~3.
13
ENTER: Press this button every time to conrm the setting or the
selection.