User`s guide

SkyTrac Systems Ltd.
Document Rev. 01.007 DOC0102 Page 22 of 23
6. Enter ‘y’ and press ENTER to proceed with the firmware upload. The firmware
upload should proceed and take approximately 1 minute to complete.
Note: The actual numbers displayed in the window will change depending on the
firmware version being uploaded. The above screenshot applies to Firmware version
1.00.06 only.
7. When the firmware upload completes press any key to close the upload DOS
window.
8. Shut off power to the DVI-250 and disconnect the Serial Cable from the programming
port on the back of the DVI-250.
Restricted Proprietary and Confidential Information