User guide

• Connecting the Power
Connect the DC power adaptor to the NVR. As the power is supplied, the Power LED will
start flickering, indicating stand-by mode. Pressing the POWER button will turn the power on
and the Power LED will light.
•
Factor
y Reset
The NVR has a Factory Reset button on the rear panel. This button will only be used on the rare
occasions that you want to return all the settings to the original factory settings.
To re
set the unit, you will need to follo
w steps:
1. Press the Factory Reset button more than 5 seconds while the NVR is operating.
2. While the NVR is initializing, the alarm LED will blink.
3. After initializing, the NVR will restart.
Caution: When using the Factory Reset, you will lose any settings you have saved.
• WPS button (HNR-E20450 model only)
The NVR has a WPS button on the rear panel. This button will be used to connect the wireless
supporting IP cameras automatically.
T
o
connect the wireless supporting IP cameras to this device, you will need to the
following steps:
1. Press the WPS button on the NVR rear part for more than 3 seconds.
2. Press the WPS button on the wireless IP camera for 3 seconds.
3. The camera can be connected automatically to the NVR and the camera image will be
displayed on the Client software window. If the connection is failed, please retry.
Note: Wireless connection can be affected by the installing conditions and the surrounding
environments, and the wireless transferring images can be vulnerable to the video / audio security and
protection.
13