Installation guide

3.3 Setting the administrator password

To gain access to the product, the password for

the default administrator user must be set. This

is done in the “Admin Password” dialog, which is

displayed when the network transmitter is

accessed for the setup at the first time. Enter

your admin name and password, set by the

administrator.

Note: The default administrator username and

password is “admin”. If the password is lost, the

Network Camera must be reset to the factory

default settings. See page 9.

3.4 Live View Page

The live view page comes in eight

screen modes like 704x480(576),

704x240(288), 352x240(288),

176x120(144), 640x480, 320x240,

and 160x120. Users are allowed to

select the most suitable one out of

those modes. Please, adjust the

mode in accordance with your PC

specifications and monitoring

purposes.

• General controls

The video drop-down list allows you to select a customized or pre-

programmed video stream on the live view page.

The resolution drop-down list allows you to select the most suitable

one out of video resolutions to be displayed on live view page.

The protocol drop-down list allows you to select which combination of

protocols and methods to use depends on your viewing requirements, and on the

properties of your network.

The preset drop-down list allows you to select the preset number for the

PTZ camera being used. This icon is inactivated if the PTZ settings are not set.