User Guide

Installation
1. Determine if you need to select the corresponding mounting clamp and rubber clip ring according to
the diameter of your handlebar (Applicable handlebar specifications：Φ22.2 ; Φ25.4 ; Φ31.8).
2. Open the display lock clamp and insert the rubber clip (if applicable) into the correct position of the lock
clamp.
3. Set the rubber ring in the bracket (if applicable) then assemble on the middle of the handlebar. You can
adjust the angle of the display to make the display screen more visible when riding. After fixing the
angle, tighten the screws. Tightening torque is 1N.m.
4. Open the lock ring of the switch and set it in the appropriate position on the left side of the handlebar.
Adjust the angle and position of the switch as needed in order to ensure that you can operate the switch
easily.
5. Fix and tighten the handlebar fixing screw with M3Hex wrench (locking torque is 0.8Nm).
6. Connect the display connector to the controller connector according to the label.
Installation
04
The information contained in this document is derived from the TFT LCD Display Guide provided by Zhejiang Topology Intelligent Technology Co., Ltd.
(otherwise known as Topology). All the information contained in this manual is published in good faith and for general information purpose only. Contact
[e-mail] for further assistance.
© 2022 CYCMOTOR LTD
Note:
Damage caused by excessive torque is not covered by warranty.
Compatibility
The clamps are suitable for 3x different handlebar sizes: 31.8mm, 25.4mm, and 22.2mm.