photon user manual
01 SAFETY & PRECAUTION • General Safety • Before the Ride • Installation & Use • Disclaimer 02 SPECIFICATION • Description • Specifications • Parts List • Dimensions • Motor Body Dimensions 1
Kindly read through the entire user manual. This manual contains important information to reduce user risk as well as instructions for this product’s proper use. Do not discard the manual but keep it for reference. Ensure that the drive unit chain has the proper tension. Incorrect tension could cause jamming of the system and result in injury while riding. Inspect the chain tension regularly.
Do not install anything other than the parts and accessories that came with this drive unit. Doing so could damage the product. The drive system can be activated and deactivated by holding down the on/off button the display. Avoid changing the bke gear (note: this is different from the drive unit’s assist level) while the drive unit is powering the bike. This may lead to excessive wear on the chain and chain rings or other gear related failture. When changing gear, use human input only.
36 - 52V >300 RPM 1500W (CYC X6) 150 N.m. (CYC X6) >90% Anodized Black 2.7kg 4.5kg 7075-T6 165mm or 175mm 190mm FOC Hall & Temp.
PHOTON assembly Bottom Bracket Spacers (3, 5 & 7mm for BSA version; 2mm (2pcs) for BB92 version) SW102 or DS103 Display Magnetic Brake Sensors (optional) Thumb, Half-Twist or Full Throttle Controller Extension Wires (optional) Magnetic Bluetooth Speed Sensor Headlights (optional) 5
FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications.
