User Guide

Error Codes
05
The information contained in this document is derived from the TFT LCD Display Guide provided by Zhejiang Topology Intelligent Technology Co., Ltd.
(otherwise known as Topology). All the information contained in this manual is published in good faith and for general information purpose only. Contact
[e-mail] for further assistance.
© 2022 CYCMOTOR LTD
Error Codes
In certain circumstances, an error code may appear on your display. Refer to the CYC Motor (BAC) mobile
application user guide for instructions on how to clear the errors and for further details on what these errors
entail. Contact [e-mail] for assistance.
Compatibility
The clamps are suitable for 3x different handlebar sizes: 31.8mm, 25.4mm, and 22.2mm.
There are transfer rings included for 25.4mm and 22.2mm (marked with L or R) as shown below. Be sure to
pay attention to the directions below to insert the transfer rings correctly.
Assembly Information
Note the torque requirements described above as excessive torque can cause damage.
Error Code Description
Instant resume not enabled
Throttle error
Hall sensor error
Communication error
Error 21H
Error 22H
Error 24H
Error 30H