Installation Guide

12 Cyclone Undermount Installation - English
MAINTENANCE
For a complete description of our maintenance and operating instructions you may visit us online at
www.CycloneRangeHoods.com to download your model’s Use and Care Guide.
• Always switch o power and unplug before cleaning and
maintenance.
WARNING
Surface and Filter Cleaning:
Clean with warm soapy water and a clean cloth. Do not use corrosive
or abrasive detergent or steel wool pads that can scratch the surface
of the machine.
Use non-abrasive stainless steel polish to bu out the luster and
grain. Scrub lightly.
e stainless steel lters trap residue and grease from cooking.
e lters should never have to be replaced but should be cleaned
thoroughly every 30 to 60 days depending on cooking habits. Filters
may be placed on the top rack of the dishwasher or soaked in warm,
soapy water.
Spray degreasing detergent and leave to soak if heavily soiled.
Replacing Lightbulbs:
• Always switch o electrical supply before carrying out any
operation on the appliance.
• In order to prevent the risk of personal injury, the halogen
lamps must be cooled before removal.
• Do not use more than 60W incandescent light bulbs for
any model. Do not use round shaped light bulb for models
NA930, NA940D, and CY1000. Recommended use 23W
orescent tube (equivalent to a 90W incandescent light
bulb).
• *Bulb & socket may change.
WARNING
Please use 23W or 15W orescent tube light bulbs for NA930/
NA940D/CY1000. Use 120V 20W halogen light bulbs for
CY1011R/CLC11/CYS1000R. Use LED bulb, 1.5W maximum
per bulb, for NA330R/NA830R/NA430R/CLN30 and CY3000R.
To change bulbs for CYS1000R and CY3000R:
1. Firmly press ngers against the lightbulb and twist counter-
clockwise until bulb is loosened
is range hood requires LED bulbs. (1.5W maximum per bulb)
To change the light bulb, remove light case from the light socket.
e light case can be accessed from the inside of the body of the
machine.
i. Disconnect the connecting wires of the light socket from the
motherboard wires.
ii. Remove grease lters and push light case outward away from
the machine.
iii. Replace with a new case.
Due to the fact that we are always striving to improve our products and take advantage of advances in technology, there may
be slight variations in your product.