Specifications

2
CYCLONE 866F OWNER’S GUIDE
Technical Specifications
Operating Voltage:
Current Consumption:
Int. Battery Charging:
Int. Batt. Siren Duration :
LED Flashing (Armed):
Operating Temp.:
Siren Blast Volume:
Siren Chirp Volume:
Housing:
Alarm Unit
Transmitter
TRANSMITTER NOTES:
• Even though the transmitter is waterproof, it is not advised to swim or
surf or dive with the transmitter, or press buttons underwater. If water
does get inside, immediately remove the batteries and allow to thor-
oughly dry out for 24 hours.
• Avoid leaving in direct sunlight for extended periods, and avoid leav-
ing near sources of intense heat.
• There are no screws used to hold the case together. To open, you may use
a at head screw driver, but note that excessive force may dent the plastic.
12Vdc
(
8v min.; 15v max.
)
Armed or Disarmed = 4.9mA
(
@8.0
~
13.0vdc, AVG.
)
;
Full Siren Blast = 270mA; SLEEP = 1.7mA
(
Immob. Off
)
Approx. 3
~
7 hours
(
while IG=ON, Temp. = 0
~
65°C
)
1 hour
(
battery used only when 12v line is cut
)
1 flash every 2 sec.
(
LED is off when Disarmed/SLEEP
)
-20°C to +65°C
(
limited by specifications of int. batt.
)
120dB @ 30cm/1ft.
(
105dB when driven by int. batt.
)
110dB @ 30cm/1ft.
(
“Soft Chirp”
)
Water-resistant
(
not “waterproof”
)
RF Output:
Digital Code:
Batteries:
Transmit Range:
Batt. Life:
Housing:
303.875MHz
(
SAW filter
)
66-bit Rolling Code
(
anti code grabbing
)
Two CR1616, 3V Lithium cells
15m / 50ft.
(
typical in-city use
)
1 year avg. @ 6 presses per day
Waterproof
(
submergible to 2 meters
)
Status LED
Light Color:
Housing:
Blue
Waterproof
(
intended for outside-bike use
)