Specifications

CYCLONE 866F OWNER’S GUIDE

System Operation

7. Manual Disarm Code. Manual disarming is useful if your transmitter

is lost or the battery dies. The factory default code is set to: 6. This fea-

ture allows you to set your own code. (30 possible code choices)

When you select this feature with transmitter Button-1, the siren will

chirp 7 times and the Status LED will ash 7 times. Now push Button-2

and the Status LED will then light solid for 10 seconds and then start

ashing slowly, up to 30 times. You must program your code during the

time that the LED ashes 30 times.

When the LED ashes the same number of times as the code you wish to

set, immediately turn off the ignition. The Status LED will then blink

the same number of times as the code you just programmed, and the siren

will chirp 3 times, and this will auto-exit the Feature Selection Menu.

For example, let’s say you wish to set your secret code to “1.” In this

case, you would enter the Feature Selection Menu and select feature No.

7 using transmitter Button-1 (the LED will blink 7 times to conrm).

Now press Button-2 and the LED will glow solid for 10 seconds. When

the 10 sec. is nished, the LED will turn off and then blink once — now

quickly turn off the Ignition. If you turned off the Ignition in time, the

LED will then blink once (to conrm your new code) and the siren will

chirp 3 times.

8. Reset Settings to Factory Default. If you have altered the settings in

the Feature Selection Menu, this feature will allow you to restore all set-

tings to their factory default, as shown in Table-2 on page 14.

When you choose Feature No. 8, the siren will chirp 8 times and the Sta-

tus LED will ash 8 times. After the 8 chirps nish, press and hold trans-

mitter button-2 until you hear 1 siren chirp (press for about 5 seconds).

If you heard the single chirp, all Cyclone feature settings are now reset.

The LED will now ash the same number of times as your Manual Dis-

arm Code, and then the siren will chirp 3 times to indicate Cyclone has

exited from Feature Programming.

Auto Arm TIPS: (1) Cyclone won’t Auto Arm while the Ignition is ON.

(2) If you like Auto Arm ON but somtimes want to Disable it, simply

Arm & Disarm after you turn off the Ignition. (3) Don’t forget that you can

program 1 or 2 sensors to be enabled during Auto Arming (Feature No.1).