Specifications

14
CYCLONE 866F OWNER’S GUIDE
System Operation
Feature Programming
TABLE-2 Feature Selection Menu
No. Feature Description Selection Chirps
1
Auto Arm Sensor Enable
(tied to No. 3 “Single Sensor” below)
Both Sensors 2
Single Sensor 1
2 Shock Sensor “Full Trigger”
ON 2
OFF
1
3
Single Sensor
(for Btn-2 Arming & Auto Arming)
Tilt 2
Shock
1
4 Duration of Full Siren Blast
30 sec. 2
10 sec.
1
5 Sensor Bypass System (SBS)
ON 2
OFF
1
6 Auto Arm
ON 2
OFF
1
7 Manual Disarm Code
6
6
8 Rest Settings to Factory Default
Press Btn-2 until siren chirps
8
FACTORY DEFAULT SETTINGS ARE BOLD & HIGHLIGHTED ABOVE
1) Arm and then Disarm Cyclone.
2) Within 20s of Disarming, turn on the Ignition.
3) Within 5s of turning on the Ignition, press both transmitter buttons (at
the same time) until the Status LED lights solid (press for about 5s). (If
you hear 1 or 3 chirps, you’ve entered Silent or Sleep Modes by accident.)
4) Press button-1 the same “No.” of times as the feature you want to change
in Table-2. The siren will chirp and LED will ash the same “No.” of times
as the feature you chose. You now have 20s to change that feature.
5) Press button-2 to toggle the feature “Selection.” The siren will chirp and
LED ash according to the new Selection (see “Chirps” column below).
6) To program another feature, repeat Steps 4 & 5. To exit Feature Pro-
gramming, turn off the Ignition. The LED will then ash according to the
number of your Manual Disarm Code, and then the siren will chirp 3 times.