Specifications

TRANSMITTER FUNCTIONS
13
ENABLE Starter Kill Immobilizer. While in Sleep Mode, turn on
IG for 3 sec, then Turn off IG and within 20 sec. press either
transmitter button (about 1 sec.) until the siren chirps 1
time. The status LED will now ash continuously. (If IG
goes on with the Immobilizer on, the siren won’t trigger.)
DISABLE Starter Kill Immobilizer. Turn on IG and
wait 3 sec. Within 20 sec. press either transmitter button
(about 1 sec.) until the siren chirps 3 times. The status LED
will stop ashing. (To then disabled Sleep Mode, see below.)
Deactivate Sleep. Turn on IG and wait 3 sec. Within 20 sec. press but-
ton-2 (about 3 sec.) until you hear 5 siren chirps. The 5 chirps conrm
that Sleep Mode is now deactivated. You can now turn off IG. (If you
hear only 3 chirps, it means you merely Disabled the Immobilizer. Turn on
IG and press Btn-2 again (3sec.) until you hear 5 chirps to Deactivate Sleep.)
LOST TRANSMITTER WHILE IN SLEEP. If you lost your only transmitter,
please start by purchasing a replacement from your Cyclone dealer.
Next, ensure IG is off, and then Disconnect Cyclone’s main harness
(noting that the siren may blast due to the backup battery), wait a few
seconds, then reconnect the harness. Sleep Mode is now deactivated.
Now use Manual Disarming (pg. 11) to Disarm. After Disarming, quick-
ly perform Transmitter Learning steps 2, 3 & 4 as described on page 17.
TABLE-1 Siren & Status LED Response to Changes in System State
ACTION or STATE SIREN STATUS LED
Arming 1 chirp 1 flash
Disarming (nothing triggered) 3 chirps
3 flashes
Disarming (Shock triggered) 3 + 1 chirps
3 + 1 flashes
Disarming (Tilt triggered) 3 + 2 chirps
3 + 2 flashes
Disarming (Ignition triggered) 3 + 3 chirps
3 + 3 flashes
Armed —
Short flash every 2s
Warn Trigger 2 chirps
2 flashes
Full Trigger 10s or 30s
Flashes for 10/30s
Panic Siren 10s or 30s
Flashes for 10/30s
Sleep Mode + Immobilizer Enabled disabled
Short flash every 2s
System Operation
Push Either
Button