Specifications

6
CYCLONE 866F OWNER’S GUIDE
Ensure the battery is connected and the Installation Harness is
properly installed.
Plug the Installation Harness connector into the 5-pin Alarm
Unit main wiring connector. Note that the full alarm blast will go
off when the connection is made. Press button-1 on the transmitter (for
about 1 sec.) to stop the siren sound. The siren will then chirp 3 times
to conrm the system is disarmed. (If you later need to disconnect the
vehiclebattery,remembertorstdisconnecttheAlarmUnitmainwiring
connector and then you may proceed with disconnecting the battery.)
Consider a mounting location for the 866F alarm unit somewhere
inside the seat. Keep in mind that your mounting location may impact
the range of the transmitter. If you later nd the transmitter range to
be inacceptable, you will need to relocate the 866F alarm unit. For this
reason it may be best to avoid afxing the 2-sided tape or the wire ties
until you have conrmed that the transmitter range is acceptable. (In-
cluded tape is useful for at-surface mounting, while the wire ties are
for mounting the alarm unit on a support bar.)
1.
2.
3.
NOTE: The installation described in this manual does not cover details of
connectingthe“universal”or“bikespecic”InstallationHarness.Please
consult the manual that came with your installation harness for details.
Once the installation harness is installed, you may then complete the in-
stallation by following the steps below.
Connecting & Mounting the Alarm Unit
CAUTIONARY POINTS
:
Although the 866F alarm unit is waterproof, it should not be submerged
in water. Make certain the installation location is not in an area that
water will collect around the alarm unit. Install only in locations that
are sheltered from the outside elements (such as within the seat).
Do not leave the 866F mounted in locations with condensing humid-
ity, high temperatures, and/or a high concentration of dust or airborne
particles.
•
•
Instal l ation