Specifications

CYCLONE 866F OWNER’S GUIDE

1

System Operation

Transmitter Learning

The transmitter learn feature is useful if you wish to purchase an optional

remote for your 866F system, or if you lose your existing remote and require

a replacement. The 866F can store up to 3 transmitters total in memory.

Note that when you learn new transmitters, all previously learned trans-

mitters will be deleted from memory for security. Therefore, each time you

initiate the learn process, you must re-learn all your transmitters. The

learn procedure is given as follows:

Make sure the 866F is not in Sleep mode, then Arm and Disarm

the system.

Within 20 sec. of Disarming, turn the Ignition key on and off 10

times. The Status LED will blink 10 times and then light solid on for

20 seconds. (If the Ignition is turned on at this stage, you will exit out of

transmitter learn, and the previously learned transmitters will remain

in memory.)

When you see the Status LED light solid, press and release but-

ton-1 on the rst transmitter you wish to learn. Previouslylearned

transmitters will now be deleted, and the siren will chirp 1 time, and the

Status LED will dim 1 time. REPEAT this step for all other transmitters

you wish to learn. You have 20 sec. of time to learn each transmitter.

After all transmitters are learned, turn Ignition on and off. (Or

you can simply wait 20 sec. for the system to auto-exit the routine.) The

Status LED should then blink the same number of times as your Manual

Disarm Code, and the siren should chirp 3 times.

IMPORTANT! Take great care of your transmitters whenever you choose

to enable the Starter Kill Immobilizer while in Sleep mode. If you lose all

your transmitters with the Immobilizer on in Sleep mode, you will be un-

able to deactivate the system or start your bike; and you cannot learn new

transmitters while in Sleep mode! In such a case, you will be forced to

remove the 866F and send it to your dealer for servicing. If you are wor-

ried about this, simply do not enable the Immobilizer while in Sleep mode.

(The Immobilizer is disabled by default in Sleep mode.)