Specifications

16
CYCLONE 866F OWNER’S GUIDE
System Operation
When you select this feature, the siren will chirp 6 times and the Status
LED will ash 6 times. The Status LED will then light solid for 10 sec.
and then ash up to 30 times. You must program your code during the
time that the LED ashes 30 times.
When the LED ashes the same number of times as the code you wish to
set, immediately turn of the ignition. The Status LED will then blink the
same number of times as the code you just programmed, and the siren
will chirp 3 times, and this will auto-exit the Feature Selection Menu.
For example, let’s say you wish to set your secret code to “1.” In this
case, you would enter the Feature Selection Menu, select feature No. 6,
watch as the LED blinks 6 times and then glows solid for 10 sec, then wait
until the LED goes off and then blinks once, then turn off the Ignition.
The LED will then blink once (the same number of times as you code) and
the siren will chirp 3 times.
Reset Settings to Factory Default. If you have altered the settings in
the Feature Selection Menu, this feature will allow you to restore all set-
tings to their factory default, as shown in Table-2 on page 14.
When you choose Feature No. 7, the siren will chirp 7 times and the Sta-
tus LED will ash 7 times. After the 7 chirps nish, press and hold trans-
mitter button-2 until you hear a single siren chirp. All settings are now
reset. The siren will then chirp 3 times to indicate you have exited from
the Feature Selection Menu.
7.