Specifications

FEATURE PROGRAMMING

1

System Operation

Description of Programmable Features

NOTE: When you select any of the 7 programmable features, the siren will

chirp the same number of times as the feature you just selected, and the

StatusLEDwillalsoashthesamenumberoftimes.Whenexitingthe

FeatureSelectionMenu,theStatusLEDwillashthesamenumberof

times as the Manual Disarm Code and then the siren will chirp 3 times.

AutoArm Sensor Enable. Allows you to select either one sensor or

both sensors to be active when the 866F automatically arms. The “Se-

lected Sensor” is chosen in Feature No. 3 (see below).

Shock Sensor “Full Trigger.” You can easily turn OFF the shock sen-

sor Full Trigger (which sounds the siren for 10/30s) simply by turning

the sensitivity POT all the way to the left (see pages 9-10). However,

this feature allows you to disable the Full Trigger while still keep your

desired Full Trigger level set on the POT. This is useful if you some-

times wish to disable the Full Trigger and then later re-enable it. You

don’t have to worry about setting the POT to what it was before.

Transmitter Button-2 Arm/AutoArm with “Selected Sensor.”

This feature allows you to select either the Tilt or the Shock sensor to

become active during these two conditions: (1) AutoArm and (2) Arming

by pressing button-2 on the transmitter. (Related to No. 1 above.)

Duration of Full Siren Blast. You can program the siren to go off for

either 10s or 30s. The Full Siren Blast goes off during a Shock Sensor

Full Trigger, Ignition Switch Trigger, Digital Tilt Trigger, Panic Siren

mode, and when the power is cut to the system (siren sounds via backup

battery).

Sensor Bypass System (SBS). SBS is a feature that prevents the

866F from becoming a public nuisance. With SBS on, the system will

automatically bypass the Tilt sensor, Shock sensor, or the Ignition sen-

sor whenever the individual sensors trigger 5 times. For example, if the

Tilt sensor triggers 5 times, SBS will disable it but the Shock and Igni-

tion sensors remain active (until they too individually trigger 5 times).

If noise pollution is not an issue for you, SBS can be turned off.

Manual Disarm Code. Manual disarming is useful if your transmit-

ter is lost or the battery dies. The factory default code is set to: 6. This

feature allows you to set your own code.