Specifications
CYCLONE 866F OWNER’S GUIDE
BACKUP BATTERY. If you have 3 hours, you can turn on the Ignition and
leave the 866F to charge the battery. When fully charged, you should be
able to disconnect the alarm unit’s main 5-pin harness and hear the siren
go off (up to 2 hours). To kill the siren, reconnect the main wiring harness,
then wait for 10 or 30 seconds for the sound to stop. If the siren went off
until the battery died, it will go off again when power is connected. Wait
until the siren stops, and then you can disarm with the transmitter.
Instal l ation
Shock Sensor Adjustments
Sensitivity POTs. Remove the rubber cap, located just above the siren
speaker on the front of the Alarm Unit. You will then see two small holes
for accessing the shock sensor adjustment potentiometers (POTs). See
Fig.3 on the next page. Do not lose the rubber cap or forget to put it back
on, otherwise water may enter and destroy the electronics!
Screw Driver. Adjustments can easily be made using the included mini
Phillips (+) screw driver. Note the arrow on the side of the screw driver
handle. This arrow can help you be more precise in your adjustments by
indicating what sensitivity level you are at, with respect to the illustra-
tions in Fig. 2 below.
FULL TRIGGER ADJUSTMENT
(hard shock detection)
O F F M A X
WARNING TRIGGER ADJUSTMENT
(light shock detection)
O F F M A X
100°
225°
20°
ADJUSTABLE
RANGE
Shock sensor factory default settings for Full & Warn triggers
FIG. 2
When you insert the screw driver into the adjustment holes, try to align
the arrow on the handle in the same position as the arrows shown above in
Fig.2. If you nd the shock setting is different from the factory default, or
if you twist by mistake, simply turn both POTs to the far left OFF position,
then align the arrow on the screw driver to the OFF position, and then you
can adjust as appropriate. In this way, the arrow on the screw driver han-
dle will show you precisely where you are in the 270° adjustment range.
0° 270° 0° 270°