User guide

Manual Slope
9:34A
TRG SLOPE
5.0% 451
WATTS
TRAINING with PowerBeam PRO using Manual WORKOUTS
Manual or “unscripted” workouts are exclusively available when using the PowerBeam Pro. When paired to a
PowerBeam Pro, two choices appear in the Workouts menu, along with any named workout files. Titled “Manual Slope”
and “Manual Power,” the choices represent Target Slope Mode and Target Power Mode, respectively. Entering either of
these areas allows the user to set the PowerBeam resistance to mimic a specific slope (grade or incline) percentage or
a specific power value. The +[PLUS] and -[MINUS] buttons can be used to increment or decrement the resistance value.
CHAPTER 7: TRAINING
INT
[ENTER]
Press & Hold
3 sec. to enter
Menus. Scroll
to Training;
Press •[ENTER] ;
Select Workouts,
FROM DASHBOARD
Training
Workouts
Auto Interval
Countdown
Back to Main Menu
9:34A
Workouts
Select a Workout
Manual Slope
Manual Power
Power Test
My Workout 1
Converted Ride 1
Back to Training
9:34A
Target slope
decrease by 0.5%
Target slope
increase by 0.5%
Manual Power
9:34A
TRG PWR
270 265
WATTS
Target power
decrease by 10w
Target power
increase by 10w
Joule GPS User Guide page 33
NOTE: Upon selecting Manual Slope or Manual Power, the Joule GPS assumes
control of the paired PowerBeam Pro without a workout script. At this point,
resistance must control the via the device +[PLUS] and -[MINUS] buttons.
Also, Manual Slope and Manual Power are only displayed in the Workouts
menu if the Device is paired to and communicating with a PowerBeam Pro.