Owner`s manual

Setup (Coded Sensor ID)

Console Setup (Coded Sensor ID)

This setup allows the console to learn a new device or

sensor suchas the hub, heart rate strap or cadence

sensor. NOTE: This process only needs to be used if a

new sensor or hub is being used in conjunction with

your console or vice versa. There are 2 learn

sequences, 1 and 2 use learn 1.

SELECT

MODE

CODED SENSOR ID

HUB 00000

SPEED 00000

HEART 00000

RESET

RETURN

1. To manually change the hub I.D. Push [Select] to

toggle through the Hub I.D. Press [Mode] to save.

SELECT

MODE

CODED SENSOR ID

HUB LEARN 1

SPEED 00000

HEART 00000

RESET

RETURN

2. If you need to “learn” the hub ID, [Select] to

advance through the Hub I.D. settings to learn 1.

NOTE: Make sure the hub is “awake” by spinning

the wheel.

3. Learn 1 is initiated by Holding [Select] until

“learn” begins flashing. When the console has

learned the device I.D. it wil display the I.D. Press

[Up or down arrow] to advance to the next device

I.D. If it did not learn the device it will take you

back to the most recent I.D.

4. Follow the above steps for any addit

ional sen-

sors you may be using, such as the heart rate strap

or cadence sensors.