Instructions / Assembly

Please read these instructions before attempting to

construct your newly purchased tricycle.

51412

CALL 877-BIKEAID (245-3243) or visit

www.bikeaidonline.com

DO NOT RETURN

THIS TRICYCLE TO THE PLACE OF PURCHASE

If you should experience a problem with your purchase,

in most cases, a BikeAid representative can resolve

your problem over the phone. Your feedback is vital to

our success and our quality improvement program.

NASCAR BURN’IN

RUBBER TRICYCLE

PAGE 1
NASCAR BURN’IN RUBBER TRICYCLE Please read these instructions before attempting to construct your newly purchased tricycle. 51412 DO NOT RETURN THIS TRICYCLE TO THE PLACE OF PURCHASE If you should experience a problem with your purchase, in most cases, a BikeAid representative can resolve your problem over the phone. Your feedback is vital to our success and our quality improvement program. CALL 877-BIKEAID (245-3243) or visit www.bikeaidonline.
PAGE 2
TRICYCLE ASSEMBLY INSTRUCTIONS 1 Open carton. 2 Layout and organize the parts. 3 Slide the plastic washer onto the fork tube.
PAGE 3
4 Insert the fork/front wheel assembly into the frame. 5 Slide the plastic clamp cover and metal clamp onto the handlebar then insert the handlebar into the fork tube 6 Tighten clamp in place and slide the plastic cover over the clamp.
PAGE 4
7 Place the frame onto the rear wheel/deck assembly and tighten in place using the hardware as shown. 8 Insert the remaining bolt through the seat. 9 Place the seat on the frame and tighten in place using the black knob.
PAGE 5
CONGRATULATIONS! Your new tricycle is now complete and ready to ride!
PAGE 6
PAGE INTENTIONALLY LEFT BLANK
PAGE 7