User`s guide

Advanced Boot and Backup Configuration Information 577
Options for the create_cf Command
2. If you are logged into the OnSite console as root through the console port,
via telnet or ssh, enter the restoreconf command.
T To Restore the OnSite Configuration Files to
the Factory Defaults
Use one of the commands shown below while logged in as root through the
console, via telnet, or via any ssh session to restore the configuration files
to the state they were in when the OnSite shipped.
• Enter the restoreconf command with the factory_default
option.
• Enter the create_cf command with the --factory_default
option.
Options for the create_cf Command
Use the create_cf command carefully as described in this section.
Only use the --doformat option to save the image that is currently in RAM
into the image1 area, but be aware that this option reformats all flash
partitions while saving the image.
Use the --image[1|2]option to save the image that is currently in RAM
into a specific image area, without reformatting the partitions that contain the
other image.
[root@ONS /]# restoreconf
[root@ONS /]# restoreconf factory_default
[root@ONS /]# create_cf --factory_default