User`s guide
Configuring Dial-Out
556
AlterPath OnSite Administrator’s and User’s Guide
T To Configure Automatic Restart of Dial-Out
in the /etc/daemon.d/gendial.sh File
1. Open the /etc/daemon.d/gendial.sh file for editing.
2. Set the ENABLE = YES.
3. Save and quit the file.
T To Restart the GDF Daemon to Activate Dial-
Out
1. Enter the daemon.sh restart GDF command to restart the GDF
daemon.
A message similar to the following displays, confirming that the GDF
daemon restarted.
The default route is not replaced in the static router table. The following
message displays.
2. Go to "To Configure a Static Route for Dial-Out.”
T To Configure a Static Route for Dial-Out
1. Open the /etc/network/st_routes file for editing.
2. Add the desired static route(s) to the file.
ENABLE = YES
[root@OnSite root]# daemon.sh restart GDF
[root@OnSite root]# Sep 23 18:06:10 src_dev_log@OnSite
showlogmsg: /bin/daemon.sh: CONFIG: Network daemon [generic-
dial] started
[root@OnSite root]# Sep 23 18:06:17 src_dev_log@CAS
pppd[1028]: not replacing existing default route to eth0
[172.20.0.1]