User`s guide
Configuring Groups on LDAP, NTLM, RADIUS, and TACACS+ Authentication Servers
518
AlterPath OnSite Administrator’s and User’s Guide
a. Log into the OnSite console and bring up the CLI utility.
b. Enter the parameters shown in the following screen example,
followed by a comma-separated list of usernames or groupnames.
3. Save and quit the file.
T To Configure Group Authorization on a NTLM
Server
This procedure installs the required tools from the Windows Server
Administration Pack that are required for configuring group authorization on
an NTLM authentication server. The primary tools are Active Directory
Schema MMC Snap-in for adding the attribute “info” to the objectclass
“Users”, and the ADSI Edit MMC Snap-in to edit the property “comment” as
“group_name=<Group1> [,<Group2,...,GroupN>];
1. Install the tools from the Windows Administration Pack.
2. Select [Start] > [Run] from the Windows desktop.
3. In the Run field type “mmc /a” and click [OK].
A console window appears.
4. Click Console in the console window menu bar and select “Add/Remove
Snap-in...”.
The “Add/Remove Snap-in” window appears.
5. Click [Add].
The “Add Standalone Snap-ins” window appears.
6. Select “Active Directory Schema” and click [Add].
7. Select “ADSI Edit” and click [Add].
8. Click [Close].
9. Click [OK] in the “Add/Remove Snap-in...” window.
cli > config physicalports serial_port_number access
users/groups comma-separated_list_of_usernames_or_groupnames