User`s guide

Web Manager for OnSite Administrators 373
Management>Microcode Reset
Management>Microcode Reset
Selecting Management>Microcode Reset in Expert mode brings up the screen
shown in the following figure.
Figure 6-127:Web Manager Management>Microcode Reset Screen
As shown in Figure 6-127, if the KVM Terminator radio button is selected, a
list of KVM ports appears.
An administrative user must use this screen to reset the microcode after an
upgrade.
T To Reset the Microcode After Upgrade
[Expert]
Perform this procedure if you have upgraded microcode as described in “To
Upgrade Firmware [Expert]” on page 267.
1. Go to Management>Microcode Reset.
The Microcode Reset screen appears.
2. To reset the microcode in a KVM terminator, do the following steps.
a. Click the KVM Terminator radio button.
A scrollable list of KVM ports appears.
b. Select the port to which the KVM terminator is connected.
3. To reset the microcode on a PS2 translation controller, select the radio
button next to “KVM Switch (internal).”